CUT & INSERT THE RODS

• Cut the fibreglass rods approx 0.5cm shorter than the rod pocket lengths.
• Insert the fibreglass rods into the pocket using end caps if you have them.
• Hand sew the ends of the rod pockets closed.

PRO TIP: Put a pencil in the far end when pushing the rods through to stop the rod getting caught on the 2cm side turn of the lining inside the pocket.

ATTACH RINGS & BREAKOUTS

You will have established the position of the cords down the back of the blind previously in STEP 9 when working out your stab stitch positions. At each point where a cord crosses a rod pocket you will now need to sew on a ring or breakout. Whether you need to use a ring or breakout will depend on the headrail and child safety breakout system you are using, please refer to the instructions with your kit.

If you are using rod pocket tape please see the extra instructions at the bottom of the page.

• Hand sew the rings and/or breakouts in the correct positions